WAH 27070

The Drierite™ Laboratory Air and Gas Drying unit is an all-purpose drier. This unit is suitable for most laboratory applications. It will dry air to a dew point of -100°F at atmospheric pressure or pressures up to 90 psig. A simple connection by rubber hose to the bottom inlet of the dryer provides an immediate flow of dry air or gas. This unit is also available with 1/8 inch SS NPT fittings (Stock No. 26840). Plastic coated mounting clips may be purchased separately. Continuous flows are possible with two units in the line and the necessary valves so that the exhausted column may be refilled while the alternate column remains in use.

Note: Do not use this plastic column in the presence of vapors or liquids containing phosphate esters, synthetic lubricants, hydrocarbon solvents, methanol, acetone, lacquer solvents, or other organics.

• Construction: Column is molded polycarbonate. Desiccant supports and coil spring are stainless steel. Polycarbonate cap is fitted with o-ring gasket. DRIERITE is held firmly in place between felt filters.
• Dimensions: 2 5/8" x 11 3/8"
• Max working pressure: 100 psig
• Connections: Hose barbs for flexible tubing ( 1/4" - 3/8" i.d.) #26800, 1/8" SS NPT fittings #26840 and 1/8" SS compression fittings #27070
• Desiccant:1 1/4 Ib. 8 mesh Indicating Drierite™
• Water capacity: 50 grams
• Recommended flow rate: 200 liters per hour or 0.1 scfm for maximum efficiency
• Pressure drop: <.01 psi at 200 lph