LCN 110816002

This general chemical, high performance fume hood was independently tested and challenged well beyond the SEFA-1 standards. With a face velocity of 40 fpm and sash fully open, the Protector XStream I-S was subjected to 50 fpm cross drafts, NIH protocol, and tracer gas measurements in the chest of the mannequin. In all scenarios, the Protector XStream I-S allowed 0.00 ppm average level of tracer gas outside the fume hood. Although your safety officer will determine the actual face velocity setting for your laboratory, the ability of this hood to contain under these adverse conditions sets a new standard of safety.

Safety is foremost, but energy savings is equally impressive. Although face velocity is a factor, it’s the volumetric rate (CFM) that determines the energy consumption. Operating a 6' Protector XStream I-S at 60 fpm face velocity, with the sash in its fully open position, requires only 690 CFM. Regardless of your desired operating face velocity, the Protector XStream I-S yields the lowest required CFM of any hood.

Features (All Models):

• By-pass airflow design
• Eco-Foil™ Air Foil with aerodynamic Clean-Sweep™ airflow openings
• Cord-Keeper™ Slots on left and right side of air foil
• Upper Dilution Air Supply
• Factory-installed Intelli-Sense Blower control box
• Factory-installed sash position activated blower speed switches
• Factory-installed Guardian™ Digital Airflow Monitor
• Glacier white powder-coated steel exterior
• Rear Downflow Dual Baffle System
• Chemical-resistant, fiberglass-reinforced, composite panel liner and baffles with flame spread index less than 25 per ASTM E84. Baffles are removable for cleaning
• Opti-Zone™ Baffle with tapered slots
• Tempered safety glass vertical-rising sash
• Powder-coated sash handle with aerodynamic Clean-Sweep™ openings
• 37.5in (95.3 cm) high sightline from the work surface to the header panel
• Removable front and side panels, and front and interior service access panels for access to plumbing and electrical wiring
• Pre-wired LED lighting with vapor-proof design and ADA-compliant light and blower switches. Lighting rated to 50,000 hours.
• Sash stop located at 18in (45.7 cm) sash opening position
• Powder-coated stainless steel, 12.81in (32.5 cm) ID exhaust connection(s)