OMNI G20-195ST
Generator probes are configured with a PTFE upper and lower bearing (400-series stainless steel bearings may be ordered). Please note that 400-series stainless steel bearings are subject to corrosion if not properly maintained. After cleaning, stainless steel bearings should be removed from the generator probe and wiped clean of all debris and moisture Stainless steel bearings should not be used when working with organic solvents or in an environment that does not allow for proper maintenance. If the generator probe is to be used with organic solvents, then it is recommended that the stainless steel bearing be replaced with a glass filled PTFE bearing (PN 10503). PTFE bearings are generally corrosion resistant, and are self-lubricating. Generator probes can be autoclaved as a complete assembly, if PTFE bearings are used. However, if it is necessary to disassemble the generator probe for special cleaning, or replacement of the rotor knife, rotor shaft, or the bearings, then follow the disassembly introductions
CAUTION: DO NOT autoclave or lubricate stainless steel bearings.